Helibug

this problem is addressed by Lynx and all the clutches are now recalled and replaced.



Recently, Lynx produced a new Gas Clutch.
One of our user "Azalyn" emailed us a picture of a Lynx Gas clutch with measured dimensions (Please check the attached picture).
[attachment=200]
I was too surprised to see those dimensions. there are very bad tolerances on the new clutches from lynx which can cause a lot of vibrations, crack a clutch bell and end up in a crash in a matter of minutes.

If you intent to use the new Lynx Gas clutch, please make absolutely sure that the clutch you have received is perfect and its without any dimensions errors before you install it.

Thank you again and Best Regards
Team Helibug

Ali thank you for posting and informing people about this issue. I hope Lynx is going to solve this soon.

Best wishes,
Azalyn

New Lynx GAS Clutch....just received.
Highly Recommended upgrade !
[attachment=226]

Thank you Ali. I'll be receiving my clutch next week. I'll mount and try it soon after and post my comments.

with the new lynx clutch are you using the standard t rex 700 clutch bell?

Yes. The stock bell with stock liner.